Filter
Top Products
Installing a flash memory or font card
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
Note: This task requires a flathead screwdriver.
1 Access the system board at the back of the printer.
a Turn the screws on the cover counterclockwise to remove them.
b Remove the cover .
Additional printer setup 30