Filter
Top Products
16
5
Press Menu> or <Menu to scroll through the list of values.
Note: Press
Return if you need to go back to previous menus or menu items without
changing the current setting.
6 When the value you want is on the second line of the display, press Select to make the value
the new user default setting.
An asterisk appears beside the value to indicate that it is now the user default setting. The new
setting shows for one second and then clears and shows the word Saved. The previous list of
menu items appears.
Note: User default settings remain in effect until you save new settings or restore factory
defaults.
7 Press Go when you have finished changing menu settings.
Locking the menus
To lock menus so changes cannot be made to user default settings:
1 Turn the printer off.
2 Press and hold the Go and Stop buttons and turn the printer on.
3 Release both buttons when Performing Self Test or Engine Warming appears.
Configuration Menu appears on the first line.
4 Press Menu> or <Menu, until Panel Menus appears on the second line.
5 Press Select.
6 Press Menu> or <Menu, until Disable appears on the second line.
7 Press Select.
CONFIG MENUS
appears on the first line and Panel Menus appears on the second line.
8 Press Menu> or <Menu, until Exit Config Menu appears on the second line.
9 Press Select.
To unlock the menus, repeat steps 1-9. However, select Enable when it appears on the second line,
instead of Disable.
If you want to disable the button sequence so users cannot easily lock or unlock the menus from the
printer operator panel, change the password variable of the PJL JOB command. Select any nonzero
value for the password variable to prevent the button sequence from unlocking (or locking) the menus.
Refer to the Technical Reference for more information about PJL commands.
Using the MarkVision remote operator panel
The MarkVision utility has a remote operator panel that shows an exact replica of the printer operator
panel on your computer screen. You can use the remote operator panel to check printer status and
change printer settings just as you would on the actual printer operator panel. If the printer is located