Filter
Top Products
Equipment Inspection and Handling
36
Figure 30 Equipment recommended for handling Liebert DS
If possible, transport the Liebert DS with a forklift or pallet jacks. If that is not possible, use a crane
with belts or cables, slings and spreader bars.
• If using a forklift or pallet jack, make sure that the forks (if adjustable) are spread to the widest
allowable distance that will fit under the skid.
Ensure the fork length is suitable for the unit length.
• When moving the packaged Liebert DS with a forklift, lift the unit from the designated “heavy
side” of the unit no higher than 6" (152mm) off the ground. Ensure that the opposite end still
touches the ground.
• The unit is to be pulled by the forklift—If the unit must be lifted higher than 6" (152mm) great
care must be exercised: Personnel who are not directly involved in moving the unit must be kept
20' (5m) or farther from the lift point of the unit.
• Always refer to the location of the center of gravity indicators when lifting the Liebert DS (see
Figure 34).
5.2 Unpacking the Unit
Remove outer packaging when ready to install the unit.
• Remove the exterior stretch wrap packaging material from around the unit, exposing the protec-
tive corner and side packaging planks.
• Remove the corner and side packaging planks from the unit, exposing the bag over the unit.
• Remove the bag from the unit when ready to remove the skid and install the unit.
Figure 31 Removing packaging
Spreader Bars and Slings
Piano Jacks
Pallet
Jack
Forklift
Step 1 Step 2 Step 3
181659P1
Rev. 5