Filter
Top Products
17
The serial terminal will display the following text at power-up:
ConsoleServer3200 Boot V1.76
Copyright 2000 by Lightwave Communications, Inc. All rights reserved.
Identify Flash
Flash ID OK
Verifying Flash Image
Starting system
Lightwave Communications, Inc. ConsoleServer3200
Please wait...system initializing
Checking non-volatile memory...
2048
Start checking and reading stored data
Reading User Start up .........
LCI3200>>
The power-on self-test may be skipped by pressing <ESC> <ESC> or <CTRL>+C, but
the ConsoleServer 3200 should be allowed to complete the POST if possible (this check
usually takes about three minutes). This information is not available on a network
connection, as it is not possible to connect to the ConsoleServer via telnet until the
power-on self-test is complete. At the completion of the power-up sequence, the
administrator is logged out, as indicated by the LCI3200>> prompt. Some commands
may be used from this prompt, but most are available only when logged in.
NOTE: The administrator may define the system prompt using the PROMPT command
(see section 6.11), but the system default prompt (LCI3200>>) is used in this manual
for clarity.
6.1.1 Logging In, Serial Connection
LCI3200>>login
Please enter password: ****
sys admin>>
To log in on the ConsoleServer through a local serial connection, type LOGIN at the
LCI3200>> prompt. The system returns the prompt Please enter password:.
The default administrator password is PASS
PASSPASS
PASS (see section 6.1.5 to change the
administrator password). The ConsoleServer will only echo stars when the password is
entered. If the password is correct, the prompt will change to sys admin>>.