Filter
Top Products
35
6.7.4 INFO
INFOINFO
INFO Command
sys admin>>INFO A
Slot A1: Modem: No Active Call Timeout = 1 mins.
Current Modem State: in command mode
Modem Init String: ATH0S0=1
Modem error: none
sys admin>INFO C
Slot C2: 0 Active Telnet Sessions Timeout = 1 mins.
Ethernet Address: 00-30-31-00-00-4F
IP=172.16.1.31 SM=255.255.255.0 GW=172.16.1.151
2nd route: IP=255.255.255.255 SM=255.255.255.255 GW=255.255.255.255
sys admin>>INFO D
Slot D1:
Port 9(A) DCE 38400,N,8,1 Flow=XON/XOFF RTS=0 DTR=1
Port 10(B) DCE 38400,N,8,1 Flow=XON/XOFF RTS=0 DTR=1
Port 11(c) DCE 38400,N,8,1 Flow=XON/XOFF RTS=0 DTR=1
Port 12(D) DCE 38400,N,8,1 Flow=XON/XOFF RTS=0 DTR=1
sys admin>>
The INFO command allows the sys admin to list the properties of a card. The switch
cards are incapable of returning information, and any request to view information from
the switch cards will be refused.
The INFO command is used in the form INFO <slot letter>, where <slot
letter> is the letter designation of the card slot in the ConsoleServer 3200 chassis.
The modem card will always be in card slot A, while the network card may be in slots B,
C, D, or E.
The modem card will return the following information:
• The slot letter and processor number (which will always be "A1")
• The connection status of the modem
• The current modem session timeout limit (see Section 6.9,Breaking User
Connections)
• The current modem state, listed as either power-up mode or command mode
• The modem initialization string sent at startup
• Any miscellaneous modem error messages
The network card will return the following information:
• The slot letter and processor number (the number will always be “2”)
• The amount of active telnet sessions
• The telnet session timeout limit
• Sys Admin sessions
• The unique hardware (MAC) address of the card, expressed as six groups of one-
byte hexadecimal numbers
• IP source 3200, BootP, RARP