Filter
Top Products
36
• The primary IP information, including: IP address, subnet mask, and gateway
• The secondary IP information, including: destination address, subnet mask, and
gateway
The terminal and device cards will return the following information:
• The terminal or device port number
• The port letter as indicated on card label
• Equipment port type (DCE or DTE)
• Baud rate
• Parity; N=none, E=even, O=odd
• Data bits
• Stop bits
• Flow control type
• Status of RTS line; 0=off, 1=on
• Status of DTR line; 0=off, 1=on
The labels “RTS” and “DTR” do not change when the port type is changed from DCE to
DTE. When the port type is changed, the label “RTS” indicates the status of the CTS
line, and “DTR” indicates the status of the DSR line.
6.7.5 POWERSTATUS
POWERSTATUSPOWERSTATUS
POWERSTATUS Command
sys admin>>POWERSTATUS
Power supply A is OK
Power supply B is OK
sys admin>>
The POWERSTATUS command displays the status of the two redundant power supplies
in the ConsoleServer 3200 chassis. Power supplies will either be listed as OK or
Failed. The ConsoleServer 3200 will continue to function with one failed power
supply. Contact Lightwave for information regarding replacement if a power supply
fails.
6.7.6 LOG
LOGLOG
LOG Command
sys admin>>log /enable
The ConsoleServer 3200 can report current system activity through control card port B.
The report is enable using the command LOG /ENABLE, and disabled using the
command LOG /DISABLE.
The system will report user logins, logouts, device port selections, and entry/exit from
direct mode. Note that there is no system clock on the ConsoleServer 3200, so there is