Filter
Top Products
40
The TELNETTIMEOUT command allows the sys admin to define the amount of time that
a network card may have an idle telnet session before breaking the network connection.
A telnet session is considered to be idle if no characters are sent from the user’s
terminal. Once the time limit has been reached, the user will be logged out and the
network connection will be broken. The connection will be broken if there is no activity
at any login level (from logged out up to direct mode). This is intended to prevent a
“dead” session from tying up system resources. This command will define the idle time
limit for all network cards present in the chassis.
To display the current system value for the idle telnet session time limit, type
TELNETTIMEOUT at the command prompt. To change the time limit, the command is
entered in the form TELNETTIMEOUT <t>, where <t> is the time limit in whole minutes.
The valid range for <t> is 0 to 30, with the default value set as 1. If the value is set to
0, then the time limit is disabled.
6.9.4 MODEMTIMEOUT
MODEMTIMEOUTMODEMTIMEOUT
MODEMTIMEOUT Command
Sys admin>>MODEMTIMEOUT
Timeout set to 5 minutes
Sys admin>>MODEMTIMEOUT 0
Timeout set to 0 minutes
0 disables the timeout from occurring
Sys admin>>MODEMTIMEOUT 2
Timeout set to 2 minutes
sys admin>>
The MODEMTIMEOUT command is identical to the TELNETTIMEOUT command, but
causes the automatic disconnection of idle modem card sessions. The modem card will
deselect any currently selected device port channel, log the user out, and disconnect
the telephone connection once the idle session time limit has been reached. Entering
the time limit in whole minutes after the command sets the idle time limit. Entering a
value of 0 will disable the timeout. Entering the command by itself will display the
current modem idle call time limit.
Any users listening to a connection that is broken by BREAK, FORCELOGOUT,
TELNETTIMEOUT, or a MODEMTIMEOUT will lose the connection as well.
6.10 Saving and Restoring System Settings
The sys admin may save all the ConsoleServer 3200 system parameter settings
(terminal port settings, device port settings, user IDs, etc.) and restore them at a later
time using the BACKUP and RESTORE commands. To use this feature, the sys admin
must be directly connected to control card port 'A' using a terminal or communications
program capable of capturing the screen output from the ConsoleServer 3200 to a plain
ASCII file to backup the system settings, and then sending the file as plain ASCII text to