Filter
Top Products
29
The NETWORK command will either display the network settings of the installed network
cards or change those settings depending on which command qualifier is used.
sys admin>>NETWORK
N-B: IP address | 000.000.000.000>
N-B: Subnet Mask | 255.255.255.255>
N-B: Enter Default Gateway address | 255.255.255.255>
N-B: Enter 2nd Dest. Network | 255.255.255.255>
N-B: Enter 2nd Netmask | 255.255.255.255>
N-B: Enter 2nd Gateway address | 255.255.255.255>
N-B: BOOTP at startup? | Y>
N-C: IP address | 000.000.000.000>
N-C: Subnet Mask | 255.255.255.255>
N-C: Enter Default Gateway address | 255.255.255.255>
N-C: Enter 2nd Dest. Network | 255.255.255.255>
N-C: Enter 2nd Netmask | 255.255.255.255>
N-C: Enter 2nd Gateway address | 255.255.255.255>
N-C: BOOTP at startup? | Y>
N-D: IP address | 000.000.000.000>
N-D: Subnet Mask | 255.255.255.255>
N-D: Enter Default Gateway address | 255.255.255.255>
N-D: Enter 2nd Dest. Network | 255.255.255.255>
N-D: Enter 2nd Netmask | 255.255.255.255>
N-D: Enter 2nd Gateway address | 255.255.255.255>
N-D: BOOTP at startup? | Y>
N-E: IP address | 000.000.000.000>
N-E: Subnet Mask | 255.255.255.255>
N-E: Enter Default Gateway address | 255.255.255.255>
N-E: Enter 2nd Dest. Network | 255.255.255.255>
N-E: Enter 2nd Netmask | 255.255.255.255>
N-E: Enter 2nd Gateway address | 255.255.255.255>
N-E: BOOTP at startup? | Y>
sys admin>>
When used without qualifiers, the NETWORK command will display the network settings
assigned to each card slot. The IP address, subnet mask, default gateway, secondary
route, and bootp settings are displayed for each slot. These parameters are assigned
to the slots rather than the cards. If a network card is moved from one slot to another, it
will have the parameters assigned to its new slot rather than those previously assigned
to it.