Filter
Top Products
Chapter 2 Cajun P333T Front and Rear Panels
Cajun P333T User’s Guide 9
Note:
To perform “Force Initial Version” reset the module and at the same tme
press the FIV reset button (use an opened paper clip or other pointed object). Let go
of the reset buttons first and then let go of the FIV button 1 or 2 seconds later.
FDX Half/Full Duplex
OFF – Half duplex mode
ON – Full duplex mode
FC
Symmetric Flow
Control
OFF – No flow control. Symmetric Pause
mode is
disabled
and/or port is in half duplex
mode
ON – Symmetric Flow Control mode is
enabled
and port is in full duplex mode
Hspd High Speed OFF – 10Base-T port or expansion port does
not exist
ON – 100Base-T, 100Base-F, and 1000Base-
X port
LAG
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 2.2 Cajun P330 <- -> Select buttons
Description Function
Left/Right Individual – select LED function (see table above)
Reset module Press both right and left buttons together for approximately two
seconds. All LEDs on module light up until buttons are released
Reset stack Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
FIV Force Initial Version – boot from backup initial version of the
Cajun P330 software, from Bank A (see Note below).
Table 2.1 Cajun P333T LED Descriptions
LED Name Description LED Status