Filter
Top Products
Chapter 5 Cajun Campus CLI (Command Line Interface)
Cajun P333T User’s Guide 51
Set port disable command
Use the set port disable command to disable a port or a range of ports (see 4.1 for
range rules).
The syntax for this command is:
set port disable
[mod_num/port_num]
Example:
Console> (enable)
set port disable
5/10
Port 5/10 disabled.
Console> (enable)
Set port speed command
Use the set port speed command to configure the speed of a port or range of ports.
You can configure the speed of a Ethernet of Fast Ethernet interface only. You can
configure Ethernet or Fast Ethernet interfaces on the 10/100-Mbps Ethernet
switching module to either 10 Mbps or 100 Mbps. In autonegotiation mode, the
port's speed is determined by autonegotiation. An error message is generated if you
attempt to set the speed type to 10 or 100 when autonegotiation is enabled.
The syntax for this command is:
set port speed
[mod_num/port_num][value]
Examples:
To configure port 2 on module 2 port speed to 10 Mbps:
Console> (enable)
set port speed
2/2 1
Port 2/2 speed set to 10 Mbps.
Console> (enable)
Set port duplex command
Use the set port duplex command to configure the duplex type of an Ethernet or
Fast Ethernet port or range of ports.
mod _num Number of the module
port_num Number of the port.
mod_num Number of the module.
port_num Number of the port on the module.
1|2 Set a port speed to 10, 100 Mbps.