Filter
Top Products
Chapter 5 Cajun Campus CLI (Command Line Interface)
54 Cajun P333T User’s Guide
Examples:
These examples show how to use the set port flowcontrol command set:
Console> (enable)
set flowcontrol
receive 5/1 on
Port 5/1 flow control receive administration status set to on
(port will require far end to send flowcontrol)
Console> (enable)
Console> (enable)
set flowcontrol
send 5/1 off
Port 5/1 flow control send administration status set to off
(port will send flowcontrol to far end)
Console> (enable)
Set trunk command
Use the set trunk command to configure the VLAN tagging mode.
The syntax for this command is:
set trunk
[mod_num/port_num][off|dot1q|plus]
Tagging capabilities are hardware dependent.
Example:
To set port 2 on module 1 as a trunk port:
Console> (enable)
set trunk
1/2 dot1q
Port(s) 1/2 trunk mode set to on.
Console> (enable)
To set port 5 on module 4 as an 802.1Q trunk port in dot1q mode:
Console> (enable)
set trunk
4/5 dot1q
Port(s) 4/5 trunk type set to dot1q.
Console> (enable)
mod_num Number of the module.
port_num Number of the port on the module.
off (Optional) Forces the port to become a non-tagging port and
persuade the neighboring port to become a non-tagging port.
The port becomes a non-tagging port even if the neighbor port
does not agree to become a non-tagging port.
dot1q (Optional) Specifies an IEEE 802.1Q tagging on a Fast Ethernet
or Gigabit Ethernet port.
Plus (Optional) Specifies private tagging to port.