Filter
Top Products
Chapter 4 Installation and Setup
22 Cajun P333T User’s Guide
Assigning Cajun P330’s IP Stack Address
Note:
All Cajun P330 switches are shipped with the same default IP address. You
must change the IP address of the master Cajun P330 switch in a stack in order to
guarantee that the stack has its own unique IP address in the network.
Changing the IP Address using Command Line Interface (CLI, Terminal Emulation)
Use the CLI to assign the Cajun P330 stack an IP address and net mask. The
CajunView station may establish communications with the stack once this address
had been assigned and the stack inserted into the network.
1 Establish a serial connection by connecting a terminal to the master Cajun P330
switch as described in the “Command Line Interface” chapter.
2 When you see the “Welcome to P330” menu and are prompted for a password,
enter the User Level password
norm
3 At the
Console
>
prompt, enter
enable
to enter the Privileged level.
4 Enter the password. The default is
enable
.
5 At the
Console>(enable)
prompt, type:
set interface <inband> <vlan> <ip_address> <netmask>
Replace
<vlan>
,
<ip_address>
and
<netmask>
with the VLAN,
IP address and net mask of the stack.
6 Press Enter to save the IP address and net mask.
7 At the
Console>(enable)
prompt, enter
reset
and press Enter to reset the
stack. After the Reset, perform login to Privileged level again as described
above.
8 At the
Console>(enable)
prompt, enter
set ip route
<dest><gateway>
where you replace
<dest>
and
<gateway>
with the
destination and gateway IP addresses.
9 Press Enter to save the destination and gateway IP addresses.
Note:
If there are any errors, the new configuration settings will not be saved. To
save the new configuration settings, you must correct the errors by repeating the
command.
10 At the
Console>(enable)
prompt, type
exit
or
disable
with the
password
(default password
norm
)
to exit the Privileged level, and press
Enter to confirm the command. The prompt changes to
Console>
to indicate
that you are in User level.
11 Exit the CLI session.
12 Insert the Cajun P330 stack into your network.