Filter
Top Products
Chapter 5 Cajun Campus CLI (Command Line Interface)
Cajun P333T User’s Guide 45
Set logout command
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout
<timeout>
Examples:
To set the number of minutes until the system disconnects an idle session
automatically:
Console> (enable) set logout 20
Sessions will be automatically logged out after 20 minutes of
idle time.
Console> (enable)
To disable the automatic disconnection of idle sessions:
Console> (enable) set logout 0
Sessions will not be automatically logged out.
Console> (enable)
Set ntp server command
The set ntp server command is used to set the ntp server address.
The syntax for this command is:
set ntp server
<ip>
Set ip route command
Use the set ip route command to add IP addresses to the IP routing table. You can
configure one default gateway up to ten-(10) default gateways for P330 family.
The syntax for this command is:
set ip route
destination gateway
<timeout> Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions
Default = 15
ip IP address of the ntp server.
destination IP address of the network, or specific host to be added
gateway IP address of the router.