Filter
Top Products
Operator's guide
11.In the next window, check that the correct hardware is shown, and click
OK to confirm.
12.You can now remove the hard disk from the computer and reinstall it in
the DCM if required.
3.3 The DCM as a GCF data source
With a sufficiently fast serial link, you can instruct the DCM to send incoming
data directly to a GCF-compatible client. For example, Güralp Systems'
Scream! software allows you to display and record incoming data, as well as
change the settings of attached digitizers. You can do this in addition to
recording data on a local hard disk, or you can leave the hard disk uninstalled
and operate the DCM entirely over the network link.
This example shows a module communicating with a local PC over a dedicated
radio link. You could also use a simple serial cable to connect the DCM to the
PC.
1. Connect the DCM to a digitizer or digital sensor.
2. Connect the DATA OUT port to a source of 12 V DC power.
December 2005 25