Filter
Top Products
Operator's guide
You can now enable the AutoDRM system under Data transfer—AutoDRM.
Click Save changes to start the service.
To test the AutoDRM system, send the following e-mail to the DCM:
From: your@e-mail.address
To: autodrm@your.DCM
BEGIN GSE2.0
MSG_TYPE request
MSG_ID unique-identifier
HELP
EMAIL your@e-mail.address
STOP
where your@e-mail.address is the e-mail address to send the return
message and unique-identifier is a string which you can use to identify
your request. autodrm@your.DCM should be replaced with an e-mail address
which will be delivered to the autodrm mailbox on the DCM.
The DCM should send a mail back to you containing help on the commands
you can give the AutoDRM.
3.5 Troubleshooting DCM installations
I cannot connect to the DCM's DATA OUT port using a terminal
program.
Press ENTER a few times to initiate communication.
If the DATA OUT port gives a login prompt, you should log in with your
username and password. If you have not been given a different username and
password, try logging in as root with the password rootme. You should
change this password as soon as you can with the command passwd
If the DATA OUT port gives an ok prompt, the DCM is running the gcf_out
service on that port and has provided you with a FORTH compatibility
interface. Type
GETTY
and press ENTER to gain access to the login prompt.
If the DATA OUT port does not respond when you press ENTER, or produces
garbage, check that your terminal program is using the same baud rate as the
DCM. By default, the DCM uses a baud rate of 115200, with 8 data bits, no
parity bit and 1 stop bit, and no flow control.
December 2005 35