Filter
Top Products
2
2.4 Interrupting a Copy Job
2-14 CF2002/CF3102
Basic Copy Operations Chapter 2
2.4 Interrupting a Copy Job
The job being printed can be interrupted.
This mode is convenient for pausing the current copy job in order to make a quick
copy of a different document.
For details on prioritizing a copy job so that it will be printed when the current job is
finished (without interrupting the current job), refer to “Increase Priority screen”
(p. 6-14).
✎
Note
Some functions cannot be interrupted.
In addition, certain functions cannot be set if the copier is in Interrupt mode. For
more details, refer to the “Function Combination Table” in the Administrator Op-
erations volume.
To interrupt copying
1
Press the [Interrupt] key while a job is being printed.
❍
The [Interrupt] key indicator lights up.
❍
The message “Now in the Interrupt mode.” appears.
(At this point, printing of the job before the interruption
continues.)
❍
The Copy mode settings return to their defaults.
(The Copy mode settings of the job before the interruption and the remaining
number of copies are recorded.)
❍
If no operation is performed for 1 minute after the [Interrupt] key is pressed,
the Interrupt mode is automatically canceled.
2
Position the document(s) to be copied.
3
Select the desired Copy mode settings.
4
Press the [Start] key.
“Stopped Print” appears below Status in the job display.
5
Scanning of the document begins.
The job queue is displayed, and the job that printing was interrupted for is added
to the queue.
6
The job that printing was interrupted for is added to the job display.