Filter
Top Products
52
8170 N/B MAINTENANCE
@ Splash Boot Logo
The “Splach boot Logo” item to enable or disable the big boot logo on screen when system is booting.
When this item is selected, no submenu will display. A check mark (√) indicates Enabled; an underline
(_) indicates Disabled. The default setting is Disabled
@ Fast Boot
The “Fast Boot” item, when enabled, speeds up the booting procedure by bypassing the memory test.
When this item is selected, no submenu will display. A check mark (√) indicates Enabled; an underline
(_) indicates Disabled. The default setting is Enabled.
@ Boot Device
The “Boot Device” item sets the sequence of booting device. When this item is selected, the submenu
will display as shown below.
( ) Hard Disk C
( ) CD-ROM Drive
(.) Diskette A
1st Boot Device
(.) Hard Disk C
( ) CD-ROM Drive
( ) Diskette A
( ) Hard Disk C
(.) CD-ROM Drive
( ) Diskette A
2nd Boot Device 3rd Boot Device
OK
OK
Cancel
Cancel
Boot Device
The default setting is Diskette A, Hard Disk C, then CD-ROM Drive
NOTE: If you set all booting options to the same device (say, Hard Disk C),. then the notebook will try to
boot from that device only