Mitsubishi Electronics HC7900DW Projector User Manual


  Open as PDF
of 55
 
EN-14
Setting up your projector (continued)
TRIGGER terminal
The TRIGGER terminals on the rear of the projector are terminals that output 12 V signal to control externally
connected devices (electric screens) when images are projected.
Ring (NC)
To externally
connected
device
Tip (12 V)
(Ground 0 V)
To TRIGGER 1
or TRIGGER 2
terminal
To use the TRIGGER terminals, set TRIGGER 1 (POWER) or TRIGGER 2 (ANAMO) to ON in the INSTALLATION menu.
(The factory default is OFF. See page 32 for details.) Use the following steps to change the setting.
With the INSTALLATION menu:
(See page 29 for menu setting.)
1. Display the INSTALLATION menu.
2. Select TRIGGER 1 (POWER) or TRIGGER 2 (ANAMO) by pressing the p or q button.
3. Select ON by pressing the t or u button.
To cancel the menu:
4. Press the MENU button.
Caution:
• DonotusethesignaloutputfromtheTRIGGERterminalsaspowerforotherdevices.
• DonotlinktheTRIGGERterminalswithaudioterminalsofotherdevicesbecausethatdevicesmaybedamaged.
• TheratedcurrentfortheTRIGGERterminalsare200mA.Ifyouuseacurrentexceedingthisrating,afailuremay
occur.
• Forinformationaboutelectricscreens,pleasecontactscreenmanufacturers.
 previous next