Mitsubishi Electronics HC7900DW Projector User Manual


  Open as PDF
of 55
 
EN-6
What’s included in the box
AC power cord* for the U.S. J2552-0063-03
for Europe J2552-0247-00
for the U.K. J2552-0065-02
for Australia J2552-0053-00
for South Korea J2552-0247-00
Computer cable J2552-0072-05
Mini DIN 5-pin cable 02552-0388-00
Remote control
User Manual/Quick Start up (English only)
Safety Manual/Quick Start up
CD-ROM (with User Manual)
Battery (2)
Lens cap
Lamp replacement attachment
* One of power cords for the U.S., Europe, U.K., Australia, and South Korea is provided appropriately.
Important:
• Theattachedpowercordistobeusedexclusivelyforthisproduct.Neveruseitforotherproducts.
Inserting the batteries into the remote control
1. Remove the back lid of the remote control.
2. Checkthepolarity(+),(-)ofthebatteries,andsetthem
correctly, inserting their (-) side first.
• Ifthebatteryisinsertedfromthe(+)siderst,
inserting the (-) side is difficult because the coil spring
end hits on the battery side. If the battery is forced in
this way, the outer label of the battery may get ripped
and it may cause a short-circuit and heating.
3. Attach the back lid.
Important:
• Usetwosize-AAbatteries(R6).
• Replacethetwobatterieswithnewoneswhenthe
remote control is slow to respond.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the batteries.
Caution:
• Useofabatteryofwrongtypemaycauseexplosion.
• OnlyCarbon-ZincorAlkaline-ManganeseDioxidetypebatteriesshouldbeused.
• Disposeofusedbatteriesaccordingtoyourlocalregulations.
• Beforeyoudisposeofthebatteries,insulatethembyplacinginsulationtapeonthepositive(+)andnegative(-)
terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may
short out, resulting in fire or explosion.
• Batteriesmayexplodeifmisused.Donotrecharge,disassemble,orheatthebatteries,orputthemintoreor
water.
• Besuretohandlethebatteriesaccordingtotheinstructions.
• Loadthebatterieswithitspositive(+)andnegative(-)sidescorrectlyorientedasindicatedontheremotecontrol.
• Keepbatteriesoutofreachofchildrenandpets.Ifchildrenswallowthebattery,seeadoctorimmediately.
• Removethebatteries,iftheremotecontrolisnotusedforalongtime.
• Donotcombineanewbatterywithanoldone.
• Ifthesolutionofbatteriescomesincontactwithyourskinorclothes,rinsewithwater.Ifthesolutioncomesin
contact with your eyes, rinse them with water and then consult your doctor.
• Donotcarryorstorethebatteriestogetherwithmetallicballpointpens,necklaces,coins,orhairpins.Otherwise,
they may short out, causing explosion or liquid leakage and resulting in fire or injury.
• Donotstorethebatterieswheretheyareexposedtodirectsunlightorsubjectedtohightemperatureandhigh
humidity. High temperature and high humidity may cause corrosion or liquid leakage.
Preparing your projector
2
3
1
 previous next