Filter
Top Products
REV 2.4
79
2.1.3.3. Manual lamp swap
In
C
C
h
h
a
a
n
n
g
g
e
e
r
r, regardless of lamp failure or brightness deterioration, you can swap lamps by
manual. During the swap, the lamp cover must be closed.
At lamp lighting, it automatically turns off the current lamp and swaps it with the spare lamp to
light. At stand-by state, it automatically turns on the power and swaps the current lamp with the
spare. Then the product shuts down to go back to the stand-by state.
[Procedure]
Press [INPUT B], [ESC] and [2-digit remote ID number] buttons in the remote control
consecutively. When the ID is 01, press [INPUT B], [ESC], [0] and [1]. Pressing [INPUT B], [ESC],
[0] and [0] swaps lamps regardless of remote ID setting.
You can also swap by pressing-and-hold the standby switch on the control panel in
P
P
H
H
5
5
0
0 and
X
X
L
L
5
5
0
0 or by pressing manual swap button on the lamp changer in
X
X
L
L
2
2
1
1.
2.1.3.4. Lamp position auto calibration
C
C
h
h
a
a
n
n
g
g
e
e
r
r has a function that can automatically adjust a lamp to the suitable position to maximize
the brightness, which is performed 5 minutes after the lamp swap.
Once calibrated, the result is automatically saved in the optical unit and it will not be re-calibrated
until the next swap is detected.
For instance, it calibrates 5 minutes after lighting a lamp that is different from a previous one, or 5
minutes after the auto-lamp changing. If you turn on the power to ignite the same lamp, the auto
calibration will not be performed since the lamp position is automatically set according to the
memorized result.
Lamp cover
Manual swap button
(in
X
X
L
L
2
2
1
1)
Standby switch
(in
P
P
H
H
5
5
0
0 and
X
X
L
L
5
5
0
0)