Mitsubishi Electronics XL50 Projector User Manual


 
REV 2.4
73
6. Tighten the two lamp fixing screws.
7.
R
R
e
e
a
a
r
r: Close the lower door.
F
F
r
r
o
o
n
n
t
t: Perform “Dust filter cleaning” (chapter
2.4.3,
on page 83) as needed, and close the screen unit
(chapter
1.2.7.2, on page 22).
8. After the replacement, perform “
Condenser lens adjustment” (chapter 2.2, on page 81),
Color balance adjustment” (chapter 1.5.2, on page 44) or “Picture outline adjustment”
(chapter
1.4.3, on page 28) as needed.
You don’t have to reset the lamp timer value since the lamp operating time is
automatically updated when a lamp is replaced. As needed, you can reset it manually in
LAMP TIMER RESET in MAINTENANCE in the system menu.
If TERGET COLOR (chapter
1.5.2.6, on page 47) has been set, the color is
automatically adjusted to be optimal at lamp replacement.
If SENSOR (chapter 1.5.2.7, on page 47) has been set RUN, the brightness is
automatically adjusted to be uniform across a display wall.
Lamp fixing
screws