Filter
Top Products
ND-70185 (E) CHAPTER 5
Page 89
Revision 3.0
DATA PROGRAMMING
Assignment of FCH Related Data
7.1.2 OGCA
A procedure for assigning OGCA access code is explained using the following example.
Figure 5-37 Example of OGCA
STEP 1: ANPDN/ANPDL
Note
Assign the first digit of the OGCA access code. When the access code is common to all nodes, use
the ANPDN command. When the access code is assigned for each node, use the ANPDL command.
1st DC=9 CI=N (Normal) NND=1
1st DC=9 CI=H (Hooking) NND=1
STEP 2: ASPAN/ASPAL
Note
Assign the OGCA access code. When the access code is common to all nodes, use the ASPAN com-
mand. When the access code is assigned for each node, use the ASPAL command.
ACC=9 CI=N (Normal) SRV=OGCA COUNT=2 1st LGRT=100 2nd LGRT=200
ACC=9 CI=H (Hooking) SRV=OGCA COUNT=2 1st LGRT=100 2nd LGRT=200
Note:
When entering the data in STEP 1 and STEP 2, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
• When writing the data on the LDM: ANPDL (STEP 1) → ASPAL (STEP 2)
• When writing the data on the NDM: ANPDN (STEP 1)
→
ASPAN (STEP 2)
STN (C)
... ... ... ... ...
... ... ... ... ...
... ... ... ... ...
... ... ... ... ...
Node C
PSTN
1-303-456-7890
Station C dials
9-1-303-456-7890
FCCS
BUSY
FCCS
COT
Node B
Node A
LGRT:200
LGRT:100
COT