Filter
Top Products
CHAPTER 8 ND-70185 (E)
Page 188
Revision 3.0
EX- FCCS
Data Programming
STEP 4: MBTC
Assign IDLE status of trunks by designating Route Number and Trunk Number.
STEP 5: ADPC
Assign the destination PC (Point Code) on RT (for speech path) number basis for all the nodes in the
EX-FCCS network.
STEP 6: ACSC
Assign the location of the CCH in CSCG (Common Channel Signaling Controller Group).
Assign thue location of the CCH using the ACSC command. The following is sample data assignment. In this
sample, PC 3 is equipped with three DTI cards. Note that if the system employs one CCIS link, enter the same
data in CSCG130 and CSCG131.
Note 1:
In the case of actual data entry, enter corresponding LEN numbers instead of letters such as “AAAAA”.
Note 2:
Refer to Figure 8-8 “Port Allocation and Related Command for CCIS Trunk”.
CSCG MG U G CICG
130
(Basic/
Primary
Route)
AAAAA0
BB B BB 1
BB B BB 2
BB B BB 3
BB B BB 4
BB B BB 5
BB B BB 6
BB B BB 7
CSCG MG U G CICG
131
(Alternate
Route)
CCCCC0
CCCCC1
CCCCC2
CCCCC3
CCCCC4
CCCCC5
CCCCC6
CCCCC7
CCH 0
CCH 1
CCH 2