Filter
Top Products
Routing Commands
290
ProSafe M4100 and M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch) #show ip ospf
Router ID.....................................2.2.2.2
OSPF Admin Mode...............................Disable
RFC 1583 Compatibility........................Enable
External LSDB Limit...........................No Limit
Exit Overflow Interval........................0
Spf Delay Time................................5
Spf Hold Time.................................10
Opaque Capability.............................Disable
AutoCost Ref BW...............................100 Mbps
Default Passive Setting.......................Disabled
Maximum Paths.................................4
Default Metric................................Not configured
Default Route Advertise.......................Disabled
Always........................................FALSE
Metric........................................Not configured
Metric Type...................................External Type 2
Default Passive
Setting
Shows whether the interfaces are passive by default.
Default Route
Advertise
Indicates whether the default routes received from other source protocols are advertised
or not.
Always
Shows whether default routes are always advertised.
Metric
The metric of the routes being redistributed. If the metric is not configured, this field is
blank.
Metric Type
Shows whether the routes are External Type 1 or External Type 2.
Number of
Active Areas
The number of active OSPF areas. An “active” OSPF area is an area with at least one
interface up.
AutoCost Ref
BW
Shows the value of auto-cost reference bandwidth configured on the router.
Maximum Paths
The maximum number of paths that OSPF can report for a given destination.
Redistributing
This field is a heading and appears only if you configure the system to take routes
learned from a non-OSPF source and advertise them to its peers.
Source
The source protocol/routes that are being redistributed. Possible values are static,
connected, or RIP.
Tag
The decimal value attached to each external route.
Subnets
For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List
The access list used to filter redistributed routes.
Term Definition