NETGEAR M4100-12G-POE+ Switch User Manual


 
Utility Commands
534
ProSafe M4100 and M7100 Managed Switches
memory free low-watermark processor
Use this command to get notifications when the CPU free memory falls below the configured
threshold. A notification is generated when the free memory falls below the threshold.
Another notification is generated once the available free memory rises to 10 percent above
the specified threshold. To prevent generation of excessive notifications when the CPU free
memory fluctuates around the configured threshold, only one Rising or Falling memory
notification is generated over a period of 60 seconds. The threshold is specified in kilobytes.
The CPU free memory threshold configuration is saved across a switch reboot.
Format
memory free low-watermark processor <1-1034956>
Mode
Logging Commands
This section describes the commands you use to configure system logging, and to view logs
and the logging settings.
logging buffered
This command enables logging to an in-memory log that keeps up to 128 logs.
Default
Format logging buffered
Mode
no logging buffered
This command disables logging to in-memory log.
Format no logging buffered
Mode
Global Config
Parameter Description
low-watermark When CPU free memory falls below this threshold, a notification message is triggered.
The range is 1 to the maximum available memory on the switch. The default is 0
(disabled).
disabled; critical when enabled
Global Config
Global Config