Filter
Top Products
IPv6 Commands
394
ProSafe M4100 and M7100 Managed Switches
exit-overflow-interval (OSPFv3)
This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering Overflow state that a router will wait before attempting to leave the
overflow state. This allows the router to again originate non-default AS-external-LSAs. When
set to 0, the router will not leave overflow state until restarted. The range for <seconds> is
0–2,147,483,647 seconds.
Default
Format exit-overflow-interval
<seconds>
Mode
no exit-overflow-interval(OSPFv3)
This command configures the default exit overflow interval for OSPF.
Format no exit-overflow-interval
Mode
external-lsdb-limit (OSPFv3)
This command configures the external LSDB limit for OSPF. If the value is –1, there is no
limit. When the number of non-default AS-external-LSAs in a router’s link-state database
reaches the external LSDB limit, the router enters overflow state. The router never holds
more than the external LSDB limit non-default AS-external-LSAs in it database. The external
LSDB limit must be set identically in all routers attached to the OSPF backbone and/or any
regular OSPF area. The range for <limit> is –1 to 2,147,483,647.
Default
Format external-lsdb-limit
<limit>
Mode
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format no external-lsdb-limit
Mode
0
Router OSPFv3 Config
Router OSPFv3 Config
-1
Router OSPFv3 Config
Router OSPFv3 Config