Filter
Top Products
Management Commands
676
ProSafe M4100 and M7100 Managed Switches
no snmptrap
Use this command to delete trap receivers for a community.
Format no snmptrap <name> {ipaddr <ipaddr|hostname> | ip6addr <ip6addr|
hostname>}
Mode
snmptrap snmpversion
Use this command to modify the SNMP version of a trap. The maximum length of <name> is
16 case-sensitive alphanumeric characters. The <snmpversion> parameter options are
snmpv1 or snmpv2.
Note: This command does not support a “no” form.
snmptrap ipaddr
Use this command to assign an IP address to a specified community name. The name can
use up to 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is
retained and processed. All duplicate entries are ignored.
Default
snmpv2
Format snmptrap <name> {ipaddr <ipaddr|hostname> | ip6addr <ip6addr|
hostname>} [snmpversion <snmpversion>]
Mode
Global Config
Global Config
Default
snmpv2
Format snmptrap snmpversion <name> {<ipaddr | hostname> |<ip6addr|hostname>}
{snmpv1|snmpv2}
Mode
Global Config