Filter
Top Products
Log Messages
722
ProSafe M4100 and M7100 Managed Switches
Table 32. 802.1Q Log Messages
Component Message Cause
802.1Q
dot1qIssueCmd: Unable to send message
%d to dot1qMsgQueue for vlan %d - %d
msgs in queue
dot1qMsgQueue is full.
802.1Q
dot1qVlanCreateProcess: Attempt to
create a vlan with an invalid vlan id %d ;
VLAN %d not in range,
Accommodates for reserved vlan ids. that
is, 4094 - x
802.1Q
dot1qMapIntfIsConfigurable: Error
accessing DOT1Q config data for
interface %d in
dot1qMapIntfIsConfigurable.
A default configuration does not exist for
this interface. Typically a case when a new
interface is created and has no
pre-configuration.
802.1Q
dot1qVlanDeleteProcess: Deleting the
default VLAN
Typically encountered during clear Vlan
and clear config
802.1Q
dot1qVlanMemberSetModify,
dot1qVlanTaggedMemberSetModify:
Dynamic entry %d can only be modified
after it is converted to static
If this vlan is a learnt via GVRP then, we
cannot modify its member set via
management.
Table 33. 802.1S Log Messages
Component Message Cause
802.1S
dot1sIssueCmd: Dot1s Msg Queue is
full!!!!Event: %u, on interface: %u, for
instance: %u
The message Queue is full.
802.1S
dot1sStateMachineRxBpdu(): Rcvd BPDU
Discarded
The current conditions, like port is not
enabled or we are currently not finished
processing another BPDU on the same
interface, does not allow us to process this
BPDU
802.1S
dot1sBpduTransmit(): could not get a buffer Out of system buffers
Table 34. Port Mac Locking Log Message
Component Message Cause
Port Mac
Locking
pmlMapIntfIsConfigurable: Error accessing
PML config data for interface %d in
pmlMapIntfIsConfigurable.
A default configuration does not exist for
this interface. Typically a case when a new
interface is created and has no
pre-configuration.