Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
Introduction 1-5
v1.0, May 2006
Hardware Description
This section describes the WG302v2 front and rear hardware functions.
Front Panel
Viewed from left to right, the WG302v2 has these status LEDs: PWR, TEST, LAN, and 802.11g
WLAN.
Figure 0-1
LED Description
PWR Power Indicator
Off No power. If this LED does not come on with the power adapter and
cord correctly installed, see Chapter 5, “Troubleshooting.
On Power is on.
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
LAN Ethernet link indicator
Off No connection detected on the Ethernet link
Amber On 10 Mbps Ethernet link detected
Amber Blink Data is being transmitted or received on the 10 Mbps Ethernet link
Green On 100 Mbps Fast Ethernet link detected.
Green Blink Data is being transmitted or received on the 100 Mbps Ethernet link