Filter
Top Products
Specifications B-1
v1.0, May 2006
Appendix B
Specifications
This appendix provides default factory settings and technical specifications for the ProSafe
802.11g Wireless Access Point.
Default Factory Settings
You can use the reset button located on the rear panel of your device to reset all settings to their
factory defaults. This is called a hard reset. To perform a hard reset, push and hold the reset button
for three seconds. Your device will return to the factory configuration settings shown in Table B-1.
Table B-1 Access Point Default Configuration Settings
Feature Description
AP Login
User Login URL 192.168.0.228
User Name (case sensitive) admin
Login Password (case sensitive) password
Ethernet Connection
Ethernet MAC Address See bottom label.
Port Speed 10/100
Basic Settings
AP Name netgearxxxxxx, where xxxxxx are the last six digits of the
wireless access point's MAC address
Country / Region United States (in North America; otherwise, varies by
region)
IP Address 192.168.0.228
Subnet Mask 255.255.255.0
DHCP Client Disabled
Spanning Tree Protocol Enabled
VLAN (802.1Q) Enabled