Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
2-22 Basic Installation and Configuration
v1.0, May 2006
3. Select the Turn Access Control On check box.
4. Either select from the list of available wireless stations the WG302v2 has found in your area,
or enter the MAC address for a device you plan to use.
You can usually find the MAC address of a wireless station printed on the wireless adapter.
Click Add to add the wireless device to the access list. Repeat these steps for each additional
device you want to add to the list.
5. Be sure to click Apply to save your wireless access control list settings.
Now, only devices on the MAC ACL will be allowed to wirelessly connect to the WG302v2.
Figure 2-9
Note: When configuring the WG302v2 from a wireless computer whose MAC
address is not in the access control list, if you select Turn Access Control On,
you will lose your wireless connection when you click Apply. You must then
access the wireless access point from a wired computer or from a wireless
computer which is on the access control list to make any further changes.