Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
C-10 Command Line Reference
v1.0, May 2006
The commands in Table C-9 correspond to the Security Profile Settings page on the Web UI. The
commands in this table show how to configure Security Profile 1, which is the default profile and
has a default profile name of NETGEAR.
Note: The commands in Table C-9 configure the default security profile, which is vap0
on radio wlan0. To configure other security profiles, use vapx, where x is the VAP
ID associated with the security profile.
Table C-9 Security Profile Settings
Task Command
Enable a security profile
set vap vap0 with radio wlan0 status up
Disable a security profile
set vap vap0 with radio wlan0 status down
Set the security profile name
set vap vap0 with radio wlan0 profile <name>
Set the SSID of the security
profile
set interface wlan0vap0 ssid <ssid_name>
Broadcast wireless network
name.
set bss wlan0bssvap0 ignore-broadcast-ssid off
Do not broadcast wireless
network name.
set bss wlan0bssvap0 ignore-broadcast-ssid on
Set Network Authentication to
Open System
set interface wlan0 security plain-text
Set Network Authentication to
Shared Key
set interface wlan0 security static-wep
Set the Data Encryption to 64-bit
WEP
set interface wlan0vap0 wep-key-length 40
Set the Data Encryption to 128-bit
WEP
set interface wlan0vap0 wep-key-length 104
Set the Key Type to ASCII
set interface wlan0vap0 wep-key-ascii yes
Set the Data Encryption to 152-bit
WEP
set interface wlan0vap0 wep-key-length 128
Set the Key Type to Hex:
set interface wlan0vap0 wep-key-ascii no