Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
Management and Information 3-5
v1.0, May 2006
3. From the main menu Management section, click the Upgrade Firmware link.
4. In the Upgrade Firmware menu, click the Browse button and browse to the location of the
image (.tar) upgrade file.
5. Click Upload.
When the upload completes, your wireless access point automatically restarts. The upgrade
process typically takes about one minute.
In some cases, you may need to reconfigure the wireless access point after upgrading.
Configuration File Management
The ProSafe 802.11g settings are stored in the wireless access point in a configuration file. This
file can be saved (backed up) to a computer, retrieved (restored) from a computer, or cleared to
factory default settings.
Click Backup/Restore Settings under the Management heading to go to the page shown in
Figure 3-4.
The following sections describes the options available on the Backup/Restore Settings page.
Figure 3-4