Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
C-14 Command Line Reference
v1.0, May 2006
Viewing and Configuring Management Settings
The commands in Table C-12 correspond to the pages on the Web UI under the Management
heading. This section includes commands for the following features:
• Change Password
• Remote Management
• Upgrade Firmware
• Backup and Restore
• Reboot the System.
Table C-12 AP Management
Task Command
Set a password for admin access
to the AP.
set system password <password>
Enable Remote CLI Access set ssh status up
Disable Remote CLI Access set ssh status down
Enable SNMP set snmp status up
Disable SNMP set snmp status down
Set a Public Community name set snmp ro-community <string>
Set a Private Community name set snmp rw-community <string>
Set an IP address to receive
SNMP traps
set traphost host <ip_address>
Upgrade the firmware (requires a
reboot)
firmware-upgrade <url>
Example:
firmware-upgrade tftp://1.2.3.4/upgrade.tar
firmware-upgrade file://1.2.3.4/tmp/upgrade.tar
Backup the configuration file
config download <url>
Example:
config download tftp://1.2.3.4/
defaultcfg.xml
Restore the configuration file
config upload <url>
Example:
config upload tftp://1.2.3.4/defaultcfg.xml
Revert to factory default settings
factory-reset
Reboot the system reboot