NETGEAR WG302v2 Network Card User Manual


 
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
Basic Installation and Configuration 2-21
v1.0, May 2006
The following list describes the RADIUS Server Settings:
Authentication Server Configuration. This configuration is required for authentication and
access control using a RADIUS Server.The IP Address, Port Number and Shared Secret are
required for communication with the RADIUS Server. You can configure a Secondary
RADIUS Server to use if the Primary RADIUS Server fails.
IP Address. The IP address of the RADIUS Server. The default is 0.0.0.0.
Port Number. The port number of the RADIUS Server. The default is 1812.
Shared Secret. This is shared between the Wireless Access Point and the RADIUS Server
while authenticating the supplicant (wireless client). The shared secret can contain up to 63
standard alphanumeric and special characters. The shared secret is case sensitive.
Accounting Server Configuration. This configuration is required for accounting using a
RADIUS Server. The IP Address, Port Number and Shared Secret are required for
communication with the RADIUS Server. You can configure a Secondary RADIUS Server to
use if the Primary RADIUS Server fails.
IP Address. The IP address of the RADIUS Server. The default is 0.0.0.0.
Port Number. Port number of the RADIUS Server. The default is 1813.
Shared Secret. This is shared between the Wireless Access Point and the RADIUS Server
while authenticating the supplicant.
Restricting Wireless Access by MAC Address
To restrict access based on MAC addresses, use the following steps:
1. Connect to the WG302v2 by entering the IP address of the WG302v2 into the address field of
your Web browser.
2. From the Security menu, click the Access Control link to display the Access Control menu
shown in Figure 2-9.