Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
3-8 Management and Information
v1.0, May 2006
Table 3-1 describes the fields on the General Information page.
Table 3-1 General Information Fields
Field Description
Access Point Information
Access Point Name
(NetBIOS name)
The name of the access point, which you can configure.
MAC Address The Media Access Control address (MAC address) of the wireless
access point’s Ethernet port.
Country/Region The domain or region for which the wireless access point is licensed for
use. It may not be legal to operate this wireless access point in a region
other than one of those identified in this field.
Firmware Version The version of the firmware currently installed.
Access Point Mode The operating mode of the WG302v2: Access Point, Point-to-point
bridge, Multi-point bridge or Repeater.
VLAN (802.1Q) Indicates if VLAN support is enabled. The default is enabled.
Current IP Settings
IP Address The IP address of the wireless access point.
Subnet Mask The subnet mask for the wireless access point.
Default Gateway The default gateway for the wireless access point communication.
DHCP Client If the DHCP Client is enabled, the current IP address was obtained
from a DHCP server on your network. Disabled indicates a static IP
configuration.
Current Wireless Settings
Operating Mode Shows the IEEE 802.11 wireless operating mode.
Channel/Frequency The channel the wireless port uses. The default channel setting is 11.
For the frequencies used on each channel, see the resources listed in
Appendix A, “Related Documents.
Rogue AP Detection Shows whether Rogue AP Detection is enabled.
Security Profiles For each Security Profile, the following information is displayed: Profile
Number, Profile Name, SSID, Security, VLAN, and Status.