Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
C-6 Command Line Reference
v1.0, May 2006
Viewing General Information
Table C-4 describes the commands you use to view some of the information that you see on the
General page of the Web UI.
The commands in the following table do not correspond to a specific Web page, but they can be
Table C-4 General Information
Task Command
Access Point Information
View Access Point Name
get host id
View the MAC Address for the Access Point
get interface brvlan1 mac
View the Country/Region
get system country
View the Firmware Version for the Access
Point
get system version
View the Access Point Mode get interface brvlan1 type
View the Untagged VLAN ID
get untagged-vlan
Current IP Settings
View the IP Address
get interface brvlan1
View the Subnet Mask
get interface brvlan1
View the Default Gateway IP address
get ip-route gateway
View the DHCP Client status
get management dhcp-client status
Current Wireless Settings
View the Operating Mode
get radio all mode
View the Channel / Frequency
get radio all channel
View whether Rogue AP Detection is
enabled
get radio all ap-detection
View information about the Security Profiles
get vap all detail