Filter
Top Products
Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-56
Command Set default gateway IP address
Description Specifies the IP address of the default IP gateway. Only
applies when the default gateway interface is
ip-ad-
dress
.
Syntax set ip gateway default [ip_address]
Arguments ip_address argument is the IP address of the default
gateway.
Example m10> set ip gateway default 191.233.22.1
Command Enable IP packet forwarding and route distribution
between ATM VCC interfaces
Description Enable/disable IP packet forwarding and route distribu-
tion between ATM VCC interfaces. If only one VCC is
used this option can be ignored.
Syntax set ip interwan-routing [on|off]
Arguments The argument enables/disables interwan routing.
Example m10> set ip interwan-routing on
Use the following commands to configure settings for routing IP over
PPP link.
Command Enable/disable routing IP over PPP link
Description Enables/disables IP routing through the specified logi-
cal ATM channel using ppp-vcmux encapsulation.
Syntax set ip ip-ppp {vccx} option [on|off]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out. The on/off argument enables/disables routing.
Example m10> set ip ip-ppp vcc1 option off
Note You must enable IP routing before you can enter other
IP routing settings for the serial port. If you turn off IP
routing and save the new configuration, the Nokia
M10 clears IP routing settings.