Filter
Top Products
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-27
Command Download software update
Description Downloads a new version of the Nokia M10 operating
software from a TFTP (Trivial File Transfer Protocol)
server, validates the software image, and programs the
image into the Nokia M10 memory. After you install new
operating software, you must restart the Nokia M10.
Syntax install [server_address] [filename] {confirm}
Arguments The TFTP server must be accessible on your Ethernet
network or through one of the active ATM virtual chan-
nels and a route to the server must exist. The server
address argument identifies the IP address of the
TFTP server on which your Nokia M10 operating soft-
ware is stored. The filename argument identifies the
path and name of the operating software file on the
TFTP server. If you include the optional confirm key-
word, you will not be prompted to identify a TFTP
server or file name. Your Nokia M10 begins the soft-
ware installation using its default boot settings.
Example M10> install 192.168.1.1 m10c_500.d39
*** WARNING *** YOU ARE ABOUT TO ERASE
AND REPROGRAM THE NOKIA M10’S PERMANENT
SOFTWARE STORAGE WITH A NEW SOFTWARE VER-
SION OBTAINED VIA THE TFTP PROTOCOL.
About to install new Flash EPROM software
image:
server: 192.168.1.1
file: “m10c_500.d39”
Do you wish to proceed? (type ’yes’ to
confirm): yes
Installing
M10>
Command Add message to log
Description Adds the message in the
message_string
argument
to the Nokia M10 diagnostic log.
Syntax log [message_string]
Arguments message_string argument is the message you want
to add to the log.
Example M10> log 05/05/99