Filter
Top Products
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-57
Command Set IP address to ATM channel using PPP-vcmux
encapsulation
Description Assigns an IP address to the specified logical ATM
channel using ppp-vcmux encapsulation.
Syntax set ip ip-ppp {vccx} address [ip_address]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out. If you specify an IP address other than 0.0.0.0,
your Nokia M10 will not negotiate its IP address with
the remote peer. If the remote peer does not accept the
IP address specified in the
ip_address argument as
valid, the link will not come up. The default value for the
ip_address argument is 0.0.0.0, which indicates that
the WAN port will use the IP address assigned to it by
the remote peer. Note that the remote peer must be
configured to supply an IP address to your Nokia M10 if
you enter 0.0.0.0 for the
ip_address argument.
Example m10> set ip ip-ppp vcc2 address 0.0.0.0
Command Set peer IP address
Description Specifies the IP address of the peer on the other end of
the logical ATM link using ppp-vcmux encapsulation.
Syntax set ip ip-ppp {vccx} peer-address [ip_address]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out.
If you specify an IP address other than 0.0.0.0,
your Nokia M10 will not negotiate the remote peer’s IP
address. If the remote peer does not accept the ad-
dress in the ip_address argument as its IP address
(typically because it has been configured with another
IP address), the link will not come up. The default value
for the ip_address argument is 0.0.0.0, which indi-
cates that the WAN port will accept the IP address re-
turned by the remote peer. If you enter 0.0.0.0, the peer
system must be configured to supply this address.
Example m10> set ip ip-ppp vcc2 peer-address
0.0.0.0