Filter
Top Products
Installation
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
4-13
web-http (80) [0 – 32767]: <Enter>
telnet-tcp (23) [0 – 32767]: <Enter>
Stepping mode ended.
M10 (top)>> save
WARNING: ’dns domain-name’ is null, indicating no
domain name is available.
WARNING: ’dns primary-address [0.0.0.0]’ and ’dns
secondary-address [0.0.0.0]’ indicates no nameserver
is available.
Configuration data saved.
M10 (top)>> exit
M10> restart
REBOOT scheduled in 2 seconds
Goodbye.
The following changes were made in the above basic router example:
D Ip-llc encapsulation was selected for the ATM channel 1. This
encapsulation is used by your company’s main office router.
Alternatively vc-mux encapsulation could be used. See Chapter 6
for more information on the payload encapsulations.
D IP address was assigned to the Ethernet port of your M10.
D IP and broadcast addresses were assigned to the ATM/ADSL
interface of your M10.
D Address mapping was disabled because your PC and M10 belong
to your company network.
D Default gateway was enabled and its IP address defines the IP
gateway interface.
D IP address of the default gateway was given.
D DHCP was disabled.
The warnings in the end of the above example indicate that the
addresses have not been specified. 0.0.0.0 setting indicates that M10
retrieves the name server addresses from the network. Warning is not
fatal. If an error message occurs the configuration has not been
validated successfully and M10 does not save the configuration.