Filter
Top Products
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-11
5.1.4 Bridge page
Bridge page is used to enable/disable bridging. When bridging is
enabled the page is used to select the interfaces which are included in
the bridging function.
Figure 5-7 Bridge page
Only those ATM interfaces which support ’ether-llc’ or ’ether-vcmux’
encapsulation or ’ppp-vcmux’ encapsulation with BNCP support can
be used in bridging operation.
Entering bridge settings
1. Turn on bridge
2. Click ATM to configure ATM channels, if needed (see Section
5.1.5).
3. Select the interfaces you want to use for bridging.
Ethernet indicates the Ethernet interface of M10. DSL VCC [N]
radio buttons indicate ATM channels using ’ether-llc’ or
’ether-vcmux’ encapsulation. WAN VCC [N] radio buttons
indicate ATM channels using ’ppp-vcmux’ encapsulation with
BNCP support.
4. Enable/disable bridging between ATM VCCs.
This option can be used when multiple M10s are connected
together using bridged connection. Disabling the bridging
between the VCCs eliminates the loops from the bridged network.