Nokia T66160 Network Card User Manual


 
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-63
Command Enable/disable RIP send function on channels
using IP over ATM or bridged encapsulations
Description Specifies whether the Nokia M10 should use Routing
information protocol (RIP) broadcasts to advertise its
routing tables to router on the other side of the speci-
fied ATM link using ip-llc, ip-vcmux, ether-llc, or ether-
vcmux encapsulation.
Syntax set ip dsl {vccx} rip-send [off | v1 | v2 | v1-compat]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using one of
these encapsulations you can leave the argument
vccx out. Both RIP version 1 and RIP version 2 func-
tionalities can be simultaneously activated. v1-compat
argument enables the sending of RIPv2 packets using
IP multicast. RIP cannot be activated if address map-
ping is ON.
Example m10> set ip dsl {vccx} rip-send off
Command Enable/disable RIP receive function on channels
using IP over ATM or bridged encapsulations
Description Specifies whether the Nokia M10 should use Routing
information protocol (RIP) broadcasts to update its rout-
ing tables with information received from other routers
on the other side of the specified ATM link using ip-llc,
ip-vcmux, ether-llc, or ether-vcmux encapsulation.
Syntax set ip dsl {vccx} rip-receive [off | v1 | v2 | v1-compat]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using one of
these encapsulations you can leave the argument
vccx out. Both RIP version 1 and RIP version 2 func-
tionalities can be simultaneously activated. v1-compat
argument enables the receiving of both RIPv1 and
RIPv2 packets. RIP cannot be activated if address
mapping is ON.
Example m10> set ip dsl vcc2 rip-receive off