Filter
Top Products
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-89
Command Set server port in LAN
Description Configures the server port where the protocol defined
by the external port number is mapped in LAN.
Syntax set pinhole item [entry_number] internal-port
[port_number]
Arguments The entry_number argument defines the unique pin-
hole entry number. The sequential values starting from
0 are accepted. The internal-port argument spec-
ifies the internal port. Valid values for port_number
are 0 – 65535.
Example m10> set pinhole item 1 internal-port 80
Integrated server settings
These command are used to configure the port number settings of the
integrated HTTP and telnet servers in M10. This is needed when
Pinhole functionality is used. The default port numbers of the
integrated HTTP and telnet servers must be changed if there is, e.g. a
Web server in the LAN and it must be accessed from the WAN. In this
case the port number of the integrated Web server in M10 must be
changed into something other than the default port number 80.
Command Set integrated Web server port number
Description Changes the port number of the integrated Web server
in M10.
Syntax set servers web-http [0 – 32767]
Arguments The argument defines the new port number for the inte-
grated Web server.
Example m10> set servers web-http 81
Command Set integrated telnet server port number
Description Changes the port number of the integrated telnet server
in M10.
Syntax set servers telnet-tcp [0 – 32767]
Arguments The argument defines the new port number for the inte-
grated telnet server.
Example m10> set servers telnet-tcp 90