Filter
Top Products
195
Using the BayStack 420 10/100/1000 Switch
Appendix D
Connectors and pin assignments
This appendix describes the BayStack 420 Switch port connectors and pin
assignments.
RJ-45 (10BASE-T/100BASE-TX) port connectors
The RJ-45 port connectors (Figure 84) are wired as MDI-X ports to connect
end stations without using crossover cables. (See “MDI and MDI-X devices” on
page 196 for information about MDI-X ports.) For 10BASE-T connections, use
Category 3 (or higher) UTP cable. For 100BASE-TX connections, use only
Category 5 UTP cable.
Figure 84 RJ-45 (8-pin modular) port connector
18
616EA