Filter
Top Products
96 Chapter 3 Using the console interface
209418-A
Choosing a BootP request mode
The BootP Request Mode field in the IP Configuration screen allows you to
choose which method the switch uses to broadcast BootP requests:
• BootP When Needed
• BootP Always
• BootP Disabled
• BootP or Last Address
In-Band Subnet
Mask
The subnet address mask associated with the in-band IP address shown on the screen
(see In-Band Switch IP address field). Network routers use the subnet mask to
determine the network or subnet address portion of a host’s IP address. The bits in the
IP address that contain the network address (including the subnet) are set to 1 in the
address mask, and the bits that contain the host identifier are set to 0.
Default Value 0.0.0.0 (no subnet mask assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, between 0 and 255, separated by a decimal
point
Default Gateway The IP address of the default gateway.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, between 0 and 255, separated by a decimal
point
Note: Whenever the switch is broadcasting BootP requests, the BootP
process will eventually time out if a reply is not received. When the
process times out, the BootP request mode automatically changes to
BootP Disabled mode. To restart the BootP process, change the BootP
request mode to any of the three following modes:
• BootP When Needed
• BootP Always
• BootP or Last Address.
Table 10 IP Configuration/Setup screen fields (continued)
Field Description