Filter
Top Products
IntroductionPassport 4400 Hardware Installation Manual
1-8
In addition to the above information you will be required to supply the following
supplemental information if your system is an XD, DD, DE or OT requiring three
or more C.O. lines:
• Sequence in which the trunks are to be connected
• Facility interface codes by position
• Service order codes by position.
Note: The FCC registration label includes the ringer equivalence,
because at the time FCC Part 68 was established, digital
systems without ringing had not been established. Even though
the ringer equivalence must appear on the label, it is
inconsequential in the case of digital communications.
Connection of this unit to the nationwide telecommunications network must be
through a standard network interface jack (RJ48C or RJ11) which must be
ordered from the telephone company.
Telephone Company Rights and Responsibilities
If your data terminal equipment causes harm to the telephone network the
telephone company may discontinue your service temporarily. If possible, they
willnotifyyou in advance.But if advance noticeis notpractical,youwillbenotified
as soon as possible. You will be given the opportunity to correct the situation, and
you will be informed of your right to file a complaint with the regulatory agency.
Yourtelephone companymay make changes in itsfacilities, equipment,operation,
or procedures that could affect the proper functioning of your data communi-
cations equipment. If they do, you will be notified in advance to give you an
opportunity to maintain uninterrupted service.
FCC Requirements
You must notify the telephone company whenever the Passport 4400 is connected
to or disconnected from a telephone company line. This equipment complies with
the Federal Communications Commission (FCC) Rules. On the back of this
equipment is alabelthatcontains,amongother information, theFCCregistration
number.
Equipment Attachment Limitations for Operation in Canada
CP-01, Part I, Section 10.1
NOTICE: The Canadian Department of Communications label identifies certified
equipment. This certification means that the equipment meets certain telecom-
munications network protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In