Filter
Top Products
iv
Notification of FCC Requirements
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part15of the FCCRules.Theselimits are designedtoprovide reasonable protectionagainstharmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and,ifnot installed and used in accordance with theinstructionmanual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Changes or modifications to this product, that could increase the amount of Radio Frequency Emissions from this
product, without the expressed written approval of Nortel/Micom could cause the product and the user to violate
the FCC’s Rules and Regulations, thus requiring the product to be turned off or disconnected.
If this unit is used on a DTE which requires use of shielded cables for compliance with FCC Part 15, then use of a
filtered pin connector may be required to maintain FCC compliance. See the Installation section for specific appli-
cations.
Notification of Canadian Requirements
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set
out in the Radio Interference Regulations of the Government of Canada Department of Industry.
Leprésentappareilnumérique n’émetpas debruits radioélectriquesdépassant leslimites applicablesaux appareils
numériques de classe A prescrites dans le règlement sur le brouillage radioélectrique édicté par le Ministère des
Industry du Canada.
United Kingdom Requirement: Interconnection of Ports Warning
Interconnection directly, or by way of other apparatus, of ports marked “SAFETY WARNING. See instructions for
use”, with ports marked or not so marked may produce hazardous conditions on the network. The advice of a
competent engineermustbe obtained before suchaconnection is made.Noneof the ports provideisolationsufficient
to satisfy the relevant parts of BS 6301. Apparatus connected to the ports, must either have been approved to the
relevant parts of BS 6301 or to have been previously evaluated against BS 6301 British Telecom Technical Guides
2 or 26, and given permission to attach. Other usage will invalidate any approval given to this apparatus.
Any or all of the ports on the following modules may be configured as non-network ports:
• Base Module: Multiple Configuration Ports
• Up to 4 Voice Modules: Up to 2 Ports
• Legacy Data Module (LDM) and Legacy Data Expansion Modules (LEM)
• High Speed Data Modules (HDM): 4 or 8 Ports