Filter
Top Products
OkiLAN 6200e Plus User’s Guide
TCP/IP 111
Note: SNMP options need to be configured only if
you are managing an Network Print Server or get-
ting system information using SNMP.
Protocol
Select the protocol for which you wish to configure trap
information.
Trap Destination
• TCP/IP Protocol - Enter the IP address to which
traps will be sent. The IP address must follow the
format XXX.XXX.XXX.XXX, where each XXX is a
number from 0 to 255. To broadcast traps to all
hosts on the local subnet, enter 255.255.255.255.
• NetWare Protocol - Enter the network number
and hardware address, respectively, to which traps
will be sent. To broadcast traps to all addresses on
all networks, enter FFFFFFFF (8 characters) in the
first field and FFFFFFFFFFFF (12 characters) in
the second field. To broadcast traps to all
addresses on a specific network, enter the network
number in the first field and then FFFFFFFFFFFF
(12 characters) in the second field.
Ports to Trap
Select the output ports on which you wish traps to be
active.
Printer Traps
Select the printer traps to be activated. The following
printer error conditions may cause a printer trap to
occur:
• On-line