Filter
Top Products
OkiLAN 6200e Plus User’s Guide
Advanced Management Features 14
over 150 configuration and status variables for the net-
work protocols, printer ports, network interfaceprinter
settings, and the overall Network Print Server status.
Printer status traps such as on-line, off-line, detached
printer and printer error are also provided.
The setting of certain variables causes an immediate
firmware reset. These variables are listed in the pri-
vate MIB under cmdReset.
Note: If you attempt a reset while a job is printing,
the job may not print successfully.
Certain variables are critical, that is, they change a
fundamental operating parameter of the Network Print
Server. These variables are saved by the Network
Print Server but are not actually used until it is power
cycled or is reset. When any one of these variables is
changed the variable genConfigDirty is automatically
set to yes by the print server. This signifies a reset is
required for all configuration changes to be made
active. We recommend checking the genConfigDirty
variable after using a MIB browser to make any config-
uration changes to the Network Print Server. If gen-
ConfigDirty is set to yes, then the cmdReset variable
should also be set to yes. This will cause the Network
Print Server to reset, make all configuration changes
active on the Network Print Server and set both the
cmdReset and genConfigDirty variables to no. These
critical variables are listed in the private MIB under
genConfigDirty.
Traps
Traps are unsolicited information from the SNMP
agent. The Network Print Server uses a ColdStart trap
to inform the manager it has been powered on or